Media Control Protocol for ew G4 series

TI 1254 v1.0 - ew G4 | 4/37
Technical information
Media control protocol description
Requirements
Supported devices
The following stationary devices will be supported the Media Control Protocol via ethernet at port
53212:
• EM 300-500 G4
• SR IEM G4
Notes
• The EM 100 G4 receiver will not be supported.
• The stationary devices require at least firmware version 1.7.0 for supporting the media control
protocol.
Recommendation for your system planning and installation
Generally external devices (e.g. large video panels, switch boxes or media control and PC systems)
may cause RF interference to wireless microphone systems.
To ensure that it works correctly, avoid RF interferences or RF transmission errors:
• Sufficient space between your wireless microphone system and all external devices is recom-
mended.
• Always use shielded wiring.
See also
Download the needed instruction manual from www.sennheiser.com.
Network requirements
• Standard LAN IPv4 with 100 Mbit/s full duplex
• UDP/IP network protocol
• The max. amount of supporting stationary devices depends on your ethernet network setup.