Media Control Protocol for ew G4 series

TI 1254 v1.0 - ew G4 | 33/37
Technical information
Media control protocol description
Equalizer [set and get]
Valid for device SR only
Description
This command adjusts the equalizer on a SR device. The status of the equalizer can also be read.
This command can be used either with 6 parameters or just with one. If only the Equalizer function
is wanted to be changed only one parameter has to be sent.
Parameters
Name Value range Get request Set request Relative
change
Equalizer 0: Equalizer off
1: Equalizer on
- X No
Low -5..+5 in step size 1 - X No
Low Mid -5..+5 in step size 1 - X No
Mid -5..+5 in step size 1 - X No
Mid High -5..+5 in step size 1 - X No
High -5..+5 in step size 1 - X No
Examples
Equalizer 0 -5 3 0 -3 5<CR>
Equalizer is off. The values for the different ranges are still taken over. In this example it means
that Low is set to -5, Low Mid is set to 3, Mid is set to 0, Mid High is set to -3 and High is set to 5.
Sennheiser device replies with Equalizer 0 -5 3 0 -3 5<CR>.
Equalizer 1<CR>
Equalizer is on. The previously stored settings are then used. Sennheiser device replies with Equal-
izer 1 -5 3 0 -3 5<CR>.
Equalizer 0 -5 3 6 -3 5<CR>
1020: Value out of range [Equalizer 0 -5 3 6 -3 5 ]<CR> Mid parameter is out of range. Therefore no
parameter is taken over.
Equalizer<CR>
A possible return could be Equalizer 1 -5 3 0 -3 5<CR>.