Media Control Protocol for ew G4 series

TI 1254 v1.0 - ew G4 | 27/37
Technical information
Media control protocol description
RF2 [get only by cyclic attributes]
Valid for device EM only
Description
This attribute is sent to media control together with other cyclic attributes.
The first parameter contains the minimum RF value of antenna 2 since last cycle. The second pa-
rameter contains the maximum RF value of antenna 2 since last cycle.
0% is consistent to 0 dBµV.
100% is consistent to 40 dBµV.
Values greater than 100% are possible.
The third parameter contains information if antenna 2 was active since last cycle. Whenever anten-
na 2 was active since last cycle Sennheiser device will set this parameter to 1 even then if most of
the time antenna 1 was active since last cycle.
Parameters
Name Value range Get request Set request Relative
change
Rf min 0.. greater 100% possible - - No
Rf max 0.. greater 100% possible - - No
Antenna 2 0: Antenna 2 was not active since
last cycle
1: Antenna 2 was at least once ac-
tive since last cycle
- - No
Examples
See chapter „Response of cyclic attributes“ on page 9.