Instruction Manual
Table Of Contents
- Important safety instructions
- The EK 300 IEM G3 diversity receiver
- Delivery includes
- Product overview
- Putting the diversity receiver into operation
- Using the diversity receiver
- Using the operating menu
- Adjusting settings via the operating menu
- Synchronizing an SR 300 IEM G3 transmitter with the diversity receiver
- Cleaning the diversity receiver
- Recommendations and tips
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
20
Adjusting settings via the operating menu
Reading out settings and saving them in profiles
From the “Advanced Menu”, call up “Engineer Mode”.
Call up the “Profiles List” menu item.
Select an unused profile (a profile without frequency entry).
Press the SET button. “ ” appears on the display panel of the
receiver.
Place the receiver‘s infra-red interface
in front of the infra-red interface
of another EK receiver.
The settings of the receiver are assigned to the selected profile.
Repeat this procedure to create profiles of other EK receivers.
Using saved profiles
From the “Engineer Mode” submenu, call up the “Load Profiles” menu
item.
Select “Active” to activate the loading of the profiles. “E” appears on
the standard di
splay.
Select a profile by pressing the UP/DOWN button / when the stan-
dard display is shown.
The selected profile is loaded, you hear the audio signal of the corre-
sponding receiver.
Resetting the settings made in the operating menu – “Reset”
When resetting the settings made in the operating menu, only the
selected settings for the pilot tone and for the frequency banks “U1” to
“U6” remain unchanged. For an overview of the factory-preset default
settings, refer to the enclosed frequency information sheet.
Displaying the software revision – “Software Revision”
You can display the current software revision of the diversity receiver.
• You can read out the data of an SR 300 IEM transmitter in the
same way. Please note, however, that these settings will only
be up-to-date if transmitter and receiver have been synchro-
nized before (“Easy Setup Sync” or “Sync”, see the instruction
ma
nual of the EK receiver).
• When the factory default settings are restored (Reset), all pro-
files are deleted.
• If there is no profile saved, “Inactive” appears in the “Load
Profiles” menu item.
•The “Engineer Mode” remains activated, even if you replace the
batteries or switch the EK off and on again.
Activate the loading
of saved profiles
Select a profile, monitor
the audio signal
Name
Load Profiles
Active
MHz
519.125
Profile 1
AFRF
P
E
MHz
516.125
Profile 3
Select a profile, monitor
the audio signal
AFRF
P
E
ESC
SET
Select the desired
setting; apply the
setting
Call up “Reset”
Advanced
Menu
Reset Yes
Reset
“Stored”
SET
SET