Instruction Manual
Table Of Contents
- Important safety instructions
- The EK 300 IEM G3 diversity receiver
- Delivery includes
- Product overview
- Putting the diversity receiver into operation
- Using the diversity receiver
- Using the operating menu
- Adjusting settings via the operating menu
- Synchronizing an SR 300 IEM G3 transmitter with the diversity receiver
- Cleaning the diversity receiver
- Recommendations and tips
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
19
Adjusting settings via the operating menu
You can adjust the limiter in 6-dB steps from –18 dB to –6 dB or switch it
off (OFF).
Adjusting the volume boost – “Volume Boost”
Adjustment range: 0 dB, +3 dB or +6 dB
To adjust the volume boost:
Call up the “Volume Boost” menu item.
Choose the desired setting. Make sure the audio signal will not be
distorted.
Store your setting.
Adjusting the contrast of the display panel – “LCD Contrast”
You can adjust the contrast of the display panel in 16 steps.
Adjusting the menu item and loading profiles – “Engineer Mode”
In “Engineer Mode”, you can read out the settings of other EK receivers and
save these settings in profiles using your EK 300 IEM G3 receiver.
These profiles can be loaded during a live transmission in order to monitor
and, if necessary, adjust an audio signal reproduced by a read-out EK
receiver.
A profile contains the settings of the menu items “Frequency Preset”,
“Name”, “Squelch”, “Mode”, “Balance”, “Tune”, “Limiter”, “Volume Boost”
and “High Boost”.
CAUTION! Danger of hearing damage due to a switched-off limiter!
The limiter limits the volume at the headphone output
PHONES and thus protects your hearing. With the limiter
sw
itched off, the receiver is capable of producing high
sound pressure levels. Prolonged exposure to high sound
pressure levels can cause permanent hearing defects.
Set the limiter to a low level before putting
the
earphones on.
Do not continuously expose yourself to high volumes.
Menu item Function of the menu item
“Profiles List” Creates up to 16 profiles and reads out the settings
of the different EK receiver.
“Load Profiles” Activates/deactivates the loading of profiles
“Clear List” Deletes all profiles
“Exit” Returns to the “Engineer Mode” menu item
Call up
“Volume Boost”
Select the desired
setting
Store the setting
Name
Advanced
Menu
Volume Boost
0 dB
0 dB
Volume Boost
“Stored”
Volume Boost
3 dB
Call up
“LCD Contrast”
Select the desired
setting
Store the setting
Name
Advanced
Menu
LCD Contrast
7
7
LCD Contrast
“Stored”
LCD Contrast
10