Instruction Manual

18
Adjusting settings via the operating menu
Selecting a channel and assigning this channel a frequency
 Set the desired frequency (MHz and kHz section) as described in the
previous chapter.
Activating/deactivating the pilot tone evaluation – “Pilot Tone”
The pilot tone encodes the stereo signal of the transmitter and supports
the diversity receiver’s squelch function, thus protecting against interfer-
ence due to RF signals from other devices. When set to stereo operation,
the transmitter adds an inaudible pilot tone to the transmitted stereo
signal. The receiver detects and evaluates the pilot tone.
 When the transmitter is set to mono oper
ation, deactivate the pilot
tone evaluation.
Adjusting the limiter – “Limiter”
 Press the UP/DOWN button / until the “Tune” menu item
appears.
 Press the SET button and keep it pressed until the frequency
bank is highlighted.
 Press the UP/DOWN button / to set the frequency bank.
 Press the SET button to confirm the frequency bank.
The channel is highlighted.
 Press the UP/DOWN button / to set the channel.
 Press the SET button to confirm the channel.
The
frequency (MHz section) is highlighted.
Display Meaning
No icon The pilot tone evaluation is deactivated.
The pilot tone evaluation is activated. The receiver does
not receive a pilot tone because the transmitter operates
in mono mode.
The pilot tone evaluation is activated. The receiver receives
a pilot tone.
SET
Select the frequency
bank and confirm
Select the channel;
store the setting
Tune
B.Ch: U1. 1
B.Ch: U5. 1
Tune
Call up “Tune”
(special function)
Advanced Menu
Tune
“Stored”
823.925 MHz
823.925 MHz 823.925 MHz
SET SET
SET
SET
SET
Call up “Pilot
Tone”
Select the desired
setting
Store the setting
Name
Advanced Menu
Pilot Tone
Active
Active
Pilot
Inactive
Pilot
“Stored”
Call up “Limiter” Select the desired
setting
Store the setting
Name
Advanced
Menu
Limiter
Off
Off
Limiter
– 6dB
Limiter
“Stored”