Instruction manual

25
Adjusting settings via the operating menu
The extended menu “Advanced Menu”
To get into the extended menu “Advanced Menu”:
 From the main menu, select “Advanced”.
Setting the receiving frequencies and the frequency banks “U1”
to “U6” – “Tune”
Via the “Tune” menu item, you can:
1. set a receiving frequency to be stored in the current channel of the
selected frequency bank (“U1” to “U6”) or
2. first select a frequency bank (“U1” to “U6”) and a channel and then
assign this channel a receiving frequency.
Setting a receiving frequency for the current channel
When you have selected one of the system banks and then select
the “Tune” menu, the diversity receiver automatically switches to
channel 1 of the frequency bank “U1”. In this case, “U1.1” briefly
appears on the display panel.
Upon delivery, the channels of the frequency banks “U1” to “U6”
are not assigned a receiving frequency.
 Press the UP/DOWN button / until the “Tune” menu item
appears.
 Press the SET button.
The MHz section of the receiving frequency of the channel is
highlighted.
It is vital to observe the notes on frequency selection on page 30.
 Press the UP/DOWN button / to set the MHz section of the
frequency.
SET
Tune
B.Ch: U1. 1
Tune
Advanced Menu
Tune
“Stored”
823.925 MHz
823.925 MHz
B.Ch: U1. 1
823.925 MHz
SET SET
SET
Select the MHz value
and confirm
Select the kHz value;
store the setting
Call up “Tune”