Instruction manual

11
Putting the diversity receiver into operation
 Place the perforated plate 씊 onto the rear of the receiver.
 Reinsert the belt clip 씍.
 Use one of the supplied line cables to connect the line input of the
camera to the socket 쐇.
 Via the operating menu of the diversity receiver, adjust the level of the
line output (AF OUT) to the input of the camera (see page 24).
 Connect a pair of headphones to the socket 쐃.
 Adjust the volume at the headphone output (PHONES) – either via the
operating menu or using the UP/DOWN button / (see page 21).
The ground connection of the line cable serves as the antenna for
the second diversity section. For details on the connector assign-
ment, refer to the diagram on page 37.
쐇
쐃