Installation Instructions
MOTION SENSOR
DESCRIPTION
SENSOR PREPARATION
shield
with the shield
If you don’t own a pet, remove the
shield :
without the shield
KRG PIR moon sensor is designed to
detect movement events and measure
room temperature.
It is a fully supervised low-current
wireless PIR detector including an
advanced Sigfox protocol radio.
1. Remove the shield
with a at screwdriver.
2. Put the regular
circle around the
«eye».
1. Clean the wall surface.
2. Remove the slice at the boom of
the detector. This will start sensor
by acvang baeries already
installed.
1. Double-sided tapes are given
to sck the sensor in the proper
posion on the wall.
2. Put sensors between 1.60m
and 1.80m above the
ground. Always choose a wall
perpendicular to the entrance
door of the room.
INSTALLATION
UP
DOWN
Door
Window
SET UP
SENSOR PREPARATION
The sensor connects automacally to
the network.
1. Red LED on the sensor, ashes
every second during one minute.
2. Green or red (depending on the
conguraon) LED lights on during 5
seconds.
3. The conguraon is set up.
Aer every baery replacement
or soware reset, the sensor will
perform the set up operaon.
The device shall keep at least 20cm
separated from the humans.
Slice
Double-sided
tapes
The sensor should
not detect out of the
room (even with the
door opened).
The sensor should
not be in front of a
window.
INSTALLATION
Make sure the sensor is well xed and
will not fall.
Window
Window
Door
Door
BATTERY CHANGE
When the baery is low (<20%), the
red light ashes every 10 seconds.
1. No need to remove the sensor
from the wall. Press on the front
of the sensor to open it
.
2. Take out old baeries.
3. Install new baeries according to
polarity marking.
4. The sensor will inialize itself
with setup conguraon (see red
LED ashing for one minute).
PRECAUTIONS
1
2
Facing
directly the
window and
sunlight.
AVOID THE FOLLOWING LOCATIONS
Hiden by
decoraons.
Facing areas
that may
quickly change
temperature.
Avoid
liquidity