User's Manual

ManualsBrandssengled ManualsElectronicsSengled Wifi Module

WF863UserManual

1. Introduction

WF863 is a cost-effective embedded wifi module launched by sengled, Custom Nodes

ESP8266 technology, ESP8266 integrates the antenna switch, RF balun, power

amplification amplifier , low noise amplifier, filter and power management The

module compact design requires very little external circuit and reduces PCB size to

minimum.

2. Module samples

3. General information

1. Support 802.11b /g/n, The frequency range is 2400 MHz ~ 2483.5 MHz

2. Tensilica L106 32 bit processing management 3. Memory: 2 M

4.Single power supply 2.7 to 3.6V, Average current: 80 mA

5. Net network protocol (2) the IPv4 / IPv6, TCP/UDP,

HTTP/HTTPS/SSL/MQTT/mDNS/CoAP

6. Straight plug installation

7.Compact size 11*13.5

8. external antenna

FCC Certification Requirements.

Summary of content (5 pages)

PAGE 1
WF863 User Manual 1. Introduction WF863 is a cost-effective embedded wifi module launched by sengled, Custom Nodes ESP8266 technology, ESP8266 integrates the antenna switch, RF balun, power amplification amplifier , low noise amplifier, filter and power management The module compact design requires very little external circuit and reduces PCB size to minimum. 2. Module samples 3. General information 1. Support 802.11b /g/n, The frequency range is 2400 MHz ~ 2483.5 MHz 2.
PAGE 2
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a mobile device. And the following conditions must be met: 1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna installation and operating configurations of this transmitter, including any applicable source-based time- averaging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements of 2.1091. 2.
PAGE 3
paragraphs: A certified modular has the option to use a permanently affixed label, or an electronic label. For a permanently affixed label, the module must be labeled with an FCC ID Section 2.926 (see 2.2 Certification (labeling requirements) above). The OEM manual must provide clear instructions explaining to the OEM the labeling requirements, options and OEM user manual instructions that are required (see next paragraph).
PAGE 4
cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. To ensure compliance with all non-transmitter functions the host manufacturer is responsible for ensuring compliance with the module(s) installed and fully operational.
PAGE 5
Le produit hôte doit être correctement étiqueté pour identifier les modules dans le produit hôte.