smart lighting expert Sengled Smart Window & Door Sensor G2 E2D-G73
Introduction: The Sengled Smart Window & Door Sensor G2 enables you to know when a door or window in your home is opened or closed. With our 3rd-party integration, you can use the sensor as a trigger to other smart devices in your home. Note: A hub is required to control the sensor. Important Safety Information: Before installing the Sengled Smart Window & Door Sensor G2, please read and follow the cautions, including: • Suitable for use in operating environment between 5°C and 40°C.
Installation Instructions: To add your Smart Sensor to a Sengled hub, follow the instructions below. If you DO NOT have a Sengled Smart Hub and Sengled Home app previously installed, please install your hub according to its user guide in the package before installing the sensor. If you have a 3rd-party hub, such as SmartThings or Amazon Echo Plus, you can also connect Sengled Smart Sensors to these hubs according to their instructions in apps.
Reset Instructions: To reset your sensor, please insert the needle included into the reset hole on the bottom and hold it for Four to Eight seconds, then release it and the LED indicator light will flash twice in red. This indicates that your sensor is starting to pair with your hub again. It will flash again when successfully paired. Operation: Your Smart Window & Door Sensor G2 only has one operational mode. Once installed, the Smart Sensor requires nothing but battery replacement when necessary.
Note: Once your sensor is paired, it will flash once after the battery being replaced successfully, and then goes into the sleep mode. If your sensor is not paired, it will try to join your hub immediately and last for one minute at most before going into the sleep mode. Frequently Asked Questions: 1. How can the Smart Sensor be connected to the netwok if it looks offline? Make sure your hub is online in the Sengled Home app by pulling down the home page to refresh the device status.
2-year limited warranty from original purchase date. To learn more about the Limited Warranty for Sengled products, please visit www.sengled.com/warranty For FCC and IC Statement details, refer to www.sengled.com/fcc If you encounter any issues, please reach out to your local Sengled Support team. Visit the following website for web support: http://support.sengled.com/ Send emails to: Support@sengled.zendesk.com (USA) SengledCnada@sengled.zendesk.
FCC Regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitationestautorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d’encompromettre le fonctionnement. Caution: This transmitter must not be co-located or operating in conjunction with any other antenna or transmit-ter.