The user manual fits for Smart Door Sensor as bellows: Smart door sensor: E1D-G73
Features • Door opened or door closed status are reported to Sengled home app, and home hub display, as well as web portal • Report the current battery remaining capacity. • Zigbee Alliance certified. Package Includes • Two E1D-G73 smart door sensors • User manual and user guide Product Specifications • Power: Battery Li+ CR1632 • Input: 3V dc, Li+ • Installation method: paste on the door or window surface close to opening or closing edge • Size: 21mm (10mm)* 49mm* 12mm / 0.83(0.39) in* 1.93in * 0.
Step 5: Follow in-app instructions to finish installation. The red LED indicator in the door sensor will flash 3 times after adding to hub successfully. Congratulations on successfully installing your smart bulbs. Troubleshoot the device 1) If the smart door sensor could not connect the Sengled hub: Press and hold on the button with a needle with package for 4-8 seconds, then release it, the door sensor will be reset to factory mode and waiting for joining a hub.
Hereby,Sengled Co., Ltd.declares that this device E1D-G73 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.The full text of the EU declaration of conformity is available at the following internet address: www.sengled.com © 2019 Sengled, Incorporated. All rights reserved. Sengled is a trademark of Sengled, Incorporated, registered in the United States and other countries. Specifications are subject to change without notice.