User's Manual

BT003UserManual
1. Introduction
BT003 intelligent lighting module is a Bluetooth 5.0 low power module based on
TLSR8253F512AT32 chip. The Bluetooth module with BLE andBluetooth mesh networking
function, Peer to peer satellite networkcommunication, using Bluetooth broadcast for
communication, can ensure timely response in case of multiple devices.
It is mainly used in intelligent light control. It can meet the requirements of low
power consumption, low delay and short distance wireless data communication.
Use for LED Lighting control , Smart Devices Switch, Remote Control or other Smart
Home device. 
2. Generalinformation
1. The frequency range is 2402 MHz ~ 2480 MHz
2. BLE 5.0 1Mbps ,Built-in Flash 512KBytes ,
3. Class 1 supported with 10.0dBm maximum TX power
4. Host Controller Interface (HCI) over UART
5. PCB antenna, Gain:1.0dBi
3. FCCStatement:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCCRadiationExposureStatement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body.
ISEDRSSWarning:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de
licence. L'exploitation

Summary of content (5 pages)