SENDUM WIRELESS, CORP. Table of Contents 1 2 Purpose ..................................................................................................... 3 Introduction .............................................................................................. 3 2.1 2.2 3 What is a PT300 .................................................................................................. 3 How does a PT300 work .....................................................................................
SENDUM WIRELESS, CORP. 1 Purpose The purpose of this guide is to describe the basic features of the PT300. 2 Introduction 2.1 What is a PT300 The PT300 is a wireless tracking device which operates on the CDMA network using assisted GPS for location. It is used for tracking valuable packages or assets. 2.2 How does a PT300 work It establishes a data connection through either the cellular or the PCS band similar to a mobile phone.
SENDUM WIRELESS, CORP. 3.2 Installing the Battery Slide the battery pack into the PT300 battery slot using the guiding tabs until the latch clicks into place. 3.3 Removing the Battery Pull the latch and slide the battery pack away from the PT300 housing at the same time. 3.4 Charging the Battery New batteries are shipped partially charged. Before you can use your device, install and charge the battery as described below. Some batteries perform best after several full charge/discharge cycles. 3.4.
SENDUM WIRELESS, CORP. Select the com port that the device is communicating, then press “Connect”. The ESN will be shown. If the device is already provisioned, the “Read” button is used to check. Now all provisioning parameters can be entered into the appropriate boxes. Press “Write” to load into the device. 5 PT300 Command Set The PT300 supports the following commands.
SENDUM WIRELESS, CORP. @RESPONSE,,PSW2,RESPONSE,LOCATE,FOUND Indicates that the device found itself. This is in response to a command to locate the device. Actual location results are returned from the PDE and vary from carrier to carrier. 6 Locating Your PT300 In order to Locate your PT300, send it the following SMS message: PSW1,LOCATE,0 6.
SENDUM WIRELESS, CORP. 7 8 9 wait 105 minutes before locating again wait 120 minutes before locating again wait 135 minutes before locating again To stop Tracking your PT300 in this mode, send it the following SMS message: PSW1,REPORT,0 6.3 Fast Tracking In order to Track (repeated locating) your PT300, send it an SMS message in the following format: PSW1,FIND Your PT300 will wait three seconds before locatiing again.
SENDUM WIRELESS, CORP. 8 Troubleshooting Email your requests to supports@sendum.
SENDUM WIRELESS, CORP. 9 Important Safety and Legal Information IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION. READ THIS INFORMATION BEFORE USING YOUR DEVICE. Never attempt to disassemble your PT300. If service or repair is required, return the device to an authorized Sendum service centre. Always use Sendum provided accessories. Use of incompatible equipment could result in fire, electric shock, or bodily injury. Never allow children to play with your PT300.
SENDUM WIRELESS, CORP. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.