SENDUM WIRELESS, CORP. Table of Contents 1 2 Purpose ................................................................................................. 3 Introduction........................................................................................... 3 2.1 2.2 3 What is a GT300 ..............................................................................................3 How does a GT300 work ..................................................................................3 Getting Started ....
SENDUM WIRELESS, CORP. 1 Purpose The purpose of this guide is to describe the basic features of the GT300. 2 Introduction 2.1 What is a GT300 The GT300 is a wireless tracking device which operates on the CDMA network using assisted GPS for location. It is used for tracking valuable assets (such as tools, machinery, etc) in construction sites. 2.2 How does a GT300 work It establishes a data connection through either the cellular or the PCS band similar to a mobile phone.
SENDUM WIRELESS, CORP. 3.2 Installing the Battery The battery is inaccessible by users 3.3 Removing the Battery The battery is inaccessible by users 3.4 Charging the Battery New batteries are shipped partially charged. Before you can use your device, install and charge the battery as described below. Some batteries perform best after several full charge/discharge cycles. 3.4.1 Charging using the GT300 Device Simply attached the Sendum charger into the device and plug the AC adapter to the AC outlet.
SENDUM WIRELESS, CORP. Select the com port that the device is communicating, then press “Connect”. The ESN will be shown. If the device is already provisioned, the “Read” button is used to check. Now all provisioning parameters can be entered into the appropriate boxes. Press “Write” to load into the device. 5 GT300 Command Set The GT300 supports the following commands.
SENDUM WIRELESS, CORP. Indicates that the device found itself. This is in response to a command to locate the device. Actual location results are returned from the PDE and vary from carrier to carrier. 6 Locating Your GT300 In order to Locate your VT100, send it the following SMS message: PSW1,LOCATE,0 6.
SENDUM WIRELESS, CORP. To stop Tracking your VT100 in this mode, send it the following SMS message: PSW1,REPORT,0 6.3 Fast Tracking In order to Track (repeated locating) your VT100, send it an SMS message in the following format: PSW1,FIND Your VT100 will wait three seconds before locatiing again.
SENDUM WIRELESS, CORP. 8 Troubleshooting Email your requests to supports@sendum.
SENDUM WIRELESS, CORP. 9 Important Safety and Legal Information IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION. READ THIS INFORMATION BEFORE USING YOUR DEVICE. Never attempt to disassemble your GT300. If service or repair is required, return the device to an authorized Sendum service centre. Always use Sendum provided accessories. Use of incompatible equipment could result in fire, electric shock, or bodily injury. Never allow children to play with your GT300.
SENDUM WIRELESS, CORP. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.