SENDUM WIRELESS, CORP. Table of Contents 1 2 Purpose ..................................................................................................... 3 Introduction .............................................................................................. 3 2.1 2.2 3 What is a OM200 ................................................................................................ 3 How does a OM200 work ...................................................................................
SENDUM WIRELESS, CORP. 1 Purpose The purpose of this guide is to describe the basic features of the OM200. 2 Introduction 2.1 What is a OM200 Ø The OM200 is a wireless tracking device which operates on the CDMA network using assisted GPS for location. Ø It is worn by offenders or minimum security prisoners on the leg so that they can be tracked by law enforcement. 2.2 How does a OM200 work Ø It establishes a data connection through either the cellular or the PCS band similar to a mobile phone.
SENDUM WIRELESS, CORP. 3.2 Installing the Battery The battery is inaccessible by users 3.3 Removing the Battery The battery is inaccessible by users 3.4 Charging the Battery New batteries are shipped partially charged. Before you can use your device, install and charge the battery as described below. Some batteries perform best after several full charge/discharge cycles. 3.4.1 Charging using the OM200 Device Simply attached the Sendum charger into the device and plug the AC adapter to the AC outlet.
SENDUM WIRELESS, CORP. Ø Select the com port that the device is communicating, then press “Connect”. The ESN will be shown. Ø If the device is already provisioned, the “Read” button is used to check. Ø Now all provisioning parameters can be entered into the appropriate boxes. Ø Press “Write” to load into the device. 5 OM200 Command Set The OM200 supports the following commands.
SENDUM WIRELESS, CORP. //BREW:0x12345678:PSW2,COMMAND,STATUS Causes the device to send a status report. //BREW:0x12345678:PSW2,COMMAND,LOCATE Causes the device to locate itself and send a location report. //BREW:0x12345678:PSW2,REPORT,STATUS, Causes the device to send a status report every seconds. //BREW:0x12345678:PSW2,REPORT,LOCATION, Causes the device to send a location report every seconds.
SENDUM WIRELESS, CORP. 5 6 7 8 9 wait 75 seconds before locating again wait 90 seconds before locating again wait 105 seconds before locating again wait 120 seconds before locating again wait 135 seconds before locating again To stop Tracking your VT100 in this mode, send it the following SMS message: PSW1,LOCATE,0 6.
SENDUM WIRELESS, CORP. 8 Troubleshooting Email your requests to supports@sendum.
SENDUM WIRELESS, CORP. 9 Exposure to Radio Frequency (RF) Signals Your Dual Band Wireless Tracking Device is a radio transmitter. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) for the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
SENDUM WIRELESS, CORP. Ø Never store or transport flammable liquids, gases, or explosive materials in the same compartment as your OM200 or any of its accessories. Ø Always secure your OM200. Never place the device on the passenger seat or anyplace else in the vehicle where it can become a projectile during collision or sudden stop. Ø Never expose your OM200 to high temperatures, such as those found near a heater.