SF-300CB SF-300 IEEE 802.11b Wireless ACCESS Bridge Product Introduction August 1, 2003 Version 0.23 (The product specification is subject to change without notice.) Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd..
SF-300CB 1. Introduction This chapter describes the package contents, system requirements, features and benefits, applications and network configurations of SF-300 Wireless Access Bridge. 1.1 Package Contents The SF-300 package contains the following item as shown in Figure. 1. 2. 3. 4. 5. 6. 7. 8. One (1) SF-300 Wireless Access Bridge One (1) 5dBi Omni rubber antenna One (1) 1m RJ-45 CAT 5 Ethernet cable One (1) 1m RS-232 Console Port Cable One (1) 24V, 0.
SF-300CB IEEE802.11b compliant Output up to 100mW Automatic data rate scaling at 11,5.5,2 and 1Mbps 64/128bits WEP data encryption/decryption Easy configuration Fully interoperable with IEEE802.
SF-300CB located nearby. The Access Point sees this Wireless Access Bridge network device combination as a standard Mobile Unit (MU). The AP forms a bridge between the wired LAN and the wireless clients. In infrastructure mode, the AP is a dedicated device that is wired into the LAN backbone while the Wireless Access Bridge units can be physically moved throughout the WLAN. The Wireless Access Bridge communicates with any device on the network by routing data through the associated AP.
SF-300CB 2. Installing and Utility This chapter describes how to install the SF-300 Wireless Access Bridge hardware. 2.1 Hardware Description 1. 2. 3. 4.
SF-300CB 3. Connecting to network 3.1 Initial setup [Blank] Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd..
SF-300CB 4. Troubleshooting [Blank] Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd..