802.
PRODUCT DESCRIPTION The EUB600-DM is a 2.4G/5G dual band 2T2R USB module base on RT5572N solution. PRODUCT SPECIFICATION RF Specification Radio 1 Support 2 . 4 G H z a n d 5GHz Interface USB 2.0 Operating Voltage 5V Antenna Connectors I-PEX Frequency Band 802.11a/b/g/n 2400~2483.5 MHz and 5150~5850 MHz Data rate 300Mbps Receive Sensitivity (Typical) 802.11g 802.11g 802.11g/n_HT20 802.11g/n_HT40 802.11a 802.11a/n_HT20 802.
PRODUCT Pin Define List of certificated antennas Type PCB Dipole Type PCB Dipole Connector 2412~2484MHz U.FL 2 Connector 5150~5250MHz U.FL 5250~5350MHz 5470~5725MHz 3 3 3 5725~5850MHz 3 Gain : 3dBi Manufacturer :Senao Networks Model name : PCB DM AIOS core module ANT Dual-1.00 T:0.6*1L-45*10(HASL)P24 PAL Note: The EUT has two antennas. (2TX/2RX) Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, As long as 2 conditions above are met, further transmitter test will not be required.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: U2M-EUB600DM”.
Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
Industry Canada statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 condition above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 3616C-EUB600DM ". Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.