User's Manual

ManualsBrandsSenao Networks ManualsElectronicsWireless 802.11abgn Access Point

Quick Installation Guide

CAP2100AG

Wireless-N 300 + 300Mbps Long Range Ceiling Mount Dual

Concurrent AP

Please verify contents of the box before continuing to set up the CAP2100AG.

 CAP2100AG Access Point

 12V/2A 100V~240V Power Adaptor

 RJ-45 Ethernet Cable

 Mounting Bracket

 Wall/Ceiling Mounting Hardware Kit

 T-Rail Mounting Hardware Kit

 CD with User's Manual

Connecting the CAP2100AG

1) Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port). For more information,

verify with User Manual.

2) Connect one end of the Category 5e Ethernet cable into RJ-45 port of the CAP2100AG and the

other end to the RJ-45 port on the computer that will use the CAP2100AG. Ensure that the cable

is securely connected to both the CAP2100AG and the Computer.

3) Connect the Power DC Inlet to the DC-IN port of the CAP2100AG and the Power to the electrical

out.

Note: CAP2100AG supports both IEEE 802.3at PoE(Power over Ethernet) and regular power adapter. You

should use either one as the power source. Please do not apply both at the same time.

Summary of content (4 pages)

PAGE 1
Quick Installation Guide CAP2100AG Wireless-N 300 + 300Mbps Long Range Ceiling Mount Dual Concurrent AP Please verify contents of the box before continuing to set up the CAP2100AG. CAP2100AG Access Point 12V/2A 100V~240V Power Adaptor RJ-45 Ethernet Cable Mounting Bracket Wall/Ceiling Mounting Hardware Kit T-Rail Mounting Hardware Kit CD with User's Manual Connecting the CAP2100AG 1) Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port).
PAGE 2
IP address configuration 1) After ensuring the EnGenius device is powered on and plugged in, ensure that your computer is on. 2) For the next steps, refer to your Operating System User Manual. 3) Once your computer is on, ensure that your TCP/IP is set to On or Enabled. (In the control panel, double click Network Connections and then double click on the connection of your Network Interface Card (NIC). Select Internet Protocol (TCP/IP) and then click on the Properties button.
PAGE 3
Using the provided hardware, the CAP2100AG can be attached to a ceiling or wall. To attach the CAP2100AG to a ceiling or wall using the mounting bracket: 1) Attach the mounting bracket to the wall or ceiling using the provided wall/ceiling mounting hardware kit. 2) Insert the provided short screws into the bottom cover of the CAP2100AG. Leave enough of the screws exposed to ensure that the unit can be attached to the mounting bracket.
PAGE 4
To attach the CAP2100AG to a ceiling using the provided T-rail connectors: 1) Attach the T-rail connectors to the bottom cover of the CAP2100AG using the provided short screws. Two sizes of T-rail connectors are included in the mounting hardware kit: 15/16in (2.38cm) and 9/16in (1.43cm). If extra space is required to accommodate drop ceiling tiles, use the provided spacers and long screws.