R1 EVO CAM R1 EVO CAM Charging Red LED: Charging Blue LED: Fully charged Power On/Off (+) Button + Center Button for 1 sec Volume Adjustment (+) Button - Increase the volume (-) Button - Decrease the volume
Battery Check Camera 1. Power On Press and Hold the Camera Button for 1 second 2. Power Off Press and Hold the Camera Button for 3 seconds 3. Start/Stop Recording Press and Hold the Camera Button for 1 second Phone, Music Pairing 1. Press the Center Button for 10 seconds. 2. Press the (+) Button to enter into Phone Pairing 3. Search for Bluetooth devices on your mobile phone. Select the SF4 in the list of the devices detected on the mobile phone. 4. Enter 0000 for the PIN.
Speed dial: Press the (+) Button for 3 seconds. Rejecting a call: Press the Center Button for 2 seconds. Intercom Pairing 1. Press and hold the Center Button of two headsets for 5 seconds until red LEDs of both units start to flash rapidly. 2. Simply tap the Center Button of any one of the two headsets. Intercom Start/End 1st Friend: Tap the Center Button once. 2nd Friend: Tap the Center Button twice.
Setting Configuration Menu: Press the Center Button for 10 seconds. Troubleshooting Factory Reset If you want to restore the R1 Pro to factory default settings, use the Factory Reset in the configuration menu. The headset automatically restores the default settings and turns off. Fault Reset If the R1 Pro is not working properly for any reason, reset by gently pushing the pin-hole reset button on the back of the main unit. mode WiFi Frequency Range (MHz) Max. Output Power(dBm) 2412~2462 1.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.