Installation Manual

PREPARATION
Knowing the Headset Layout
Headset
Charging LED
Status LED
Phone Button
Jog Dial
DC Power Charging &
Firmware Upgrade Port
Clamp Unit
Microphone
Connector
MP3 Port
Left Speaker
Connector
Earbud Port
Right Speaker
Connector
BASIC OPERATION
Operating the Buttons
5
Tap the
button
Double tap the
button
Press and hold
the button for
5 seconds
Press the two
buttons at the
same time
Rotate the
Jog Dial
Turning On/O the Headset
1
ON
You will hear ascending
beeps.
“Hello”
OFF
You will hear descending
beeps.
“Good bye”
Simultaneously press and hold the Jog Dial and the Phone Button
for 1 second to turn on or o the headset.
Adjusting the Volume
You will hear a beep when the volume
reaches the maximum or minimum
level.
PAIRING
Pairing with Mobile Devices - Phone, Music
“Phone pairing”
Bluetooth
Bluetooth
Sena10S
“Your headset is paired”
Checking the Battery Level
Blinking
70~100%
Blinking
30~70%
Blinking
0~30%
Turn on the headset and check the battery level via the Status LED.
3
“High” 70~100%
“Medium” 30~70%
“Low” 0~30%
Or, press and hold the Jog Dial and the Phone Button for 3 more
seconds when the headset turns on. You will hear a triple beep
and a voice prompt.
Charging the Battery
Charging
Fully charged
AC adapter
or
Using Phone Features
After Pairing…
Answering Calls
Ending Calls Rejecting Calls
or
or
or
“Hello”
until you hear a beep until you hear a beep
Making Calls
Using the Phone Keypad Using the Voice Dialer
Installing the Headset
1
2
1
3
2
1
2
1
2
1
2
Clamp Unit
Speaker
Microphone
Headset
Left
Right