U-COM 16 (SP93) Manual Charging Red LED: Charging Blue LED: Fully charged Power On/Off Power On : Music & Volume + Button + Intercom Button for 1 sec Power On : Tap the Music & Volume + Button + Intercom Button.
Battery Check Phone, Music Pairing 1. To access Configuration Menu, press and hold the Intercom Button for 10 second. 2. To enter Phone Pairing, tap the Music & + Button for 1 second. 3. Search for Bluetooth devices on your mobile phone. Select the headset in the list of the devices detected on the mobile phone. 4. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN. Music Operation Play music: Press the Music & Volume + Button for 1 second.
Track back: Double tap the Phone & Volume - Button. Track forward: Double tap the Music & Volume+ Button. Mobile Phone Call Making and Answering Answering a call: Press the Phone & Volume - Button for 1 second. Ending a call: Press the Phone & Volume - Button for 2 seconds. Speed dial: Press the Phone & Volume - Button for 3 seconds. Rejecting a call: Press the Phone & Volume - Button for 2 seconds. Mesh Intercom On/Off Tap the Intercom Mesh Button. Intercom Pairing 1.
Setting Configuration Menu: Press the Intercom Button for 10 seconds. Using the Device Manager Connect the headset to your computer via a USB cable. Launch the Device Manager and click DEVICE SETTING to configure the headset settings. For details about downloading the Sena Manager, please refer to the leaflet included in the package. Troubleshooting Factory Reset If you want to restore the headset to factory default settings, use the Factory Reset in the configuration menu.
Certification and Safety Approvals FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules.
protection raisonnable contre les interférences nuisibles dans une installation résidentielle. Cet équipement génère et utilise de l’énergie radio fréquence et, s’il n’est pas installé et utilisé conformément. aux instructions, il peut occasionner des interférences nuisibles au niveau des communications radios. Cependant, il n’existe aucune garantie que ces interférences ne se produiront pas dans une installation particulière.
IC RF Exposure Statement Cet équipement est conforme aux limites d'exposition aux radiations de la FCC définies pour un environnement non contrôlé. Les utilisateurs finaux doivent suivre les instructions d'utilisation spécifiques pour satisfaire à la conformité d'exposition RF. L'antenne utilisée pour cet émetteur ne doit pas émettre simultanément avec d'autres antennes ou émetteurs, sauf en conformité avec les procédures FCC relatives aux produits multi-émetteurs.