U-COM 4(U-COM 2) Manual Charging Red LED: Charging Blue LED: Fully charged Power On/Off Music Button + Center Button for 1 sec Volume Adjustment Music Button - Increase the volume Phone Button - Decrease the volume Battery Check
Phone, Music Pairing 1. To access Configuration Menu, press and hold the Center Button for 10 second. 2. To enter Phone Pairing, tap the Music Button for 1 second. 3. Search for Bluetooth devices on your mobile phone. Select the headset in the list of the devices detected on the mobile phone. 4. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN. Music Operation Play music: Press the Music Button for 1 second. Pause music: Press the Music Button for 2 second.
Ending a call: Press the Phone Button for 2 seconds. Speed dial: Press the Phone Button for 3 seconds. Rejecting a call: Press the Phone Button for 2 seconds. Intercom Pairing 1. Press and hold the Center Button of two Bluetooth systems for 5 seconds until red LEDs of both units start to flash rapidly. 2. The two headsets will be automatically paired. Intercom Start/End 1st Friend: Tap the Center Button once. 2nd Friend: Tap the Center Button twice.
Seek down stations: Press the Phone Button for 1 second. Setting Configuration Menu: Press the Center Button for 10 seconds. Troubleshooting Factory Reset If you want to restore the headset to factory default settings, use the Factory Reset in the configuration menu. The headset automatically restores the default settings and turns off.
Certification and Safety Approvals FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules.
protection raisonnable contre les interférences nuisibles dans une installation résidentielle. Cet équipement génère et utilise de l’énergie radio fréquence et, s’il n’est pas installé et utilisé conformément. aux instructions, il peut occasionner des interférences nuisibles au niveau des communications radios. Cependant, il n’existe aucune garantie que ces interférences ne se produiront pas dans une installation particulière.
IC RF Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. The antenna used for this transmitter must not transmit simultaneously with any other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures. When equipped, the distance between antenna and one’s head surface is 35mm.