User Manual

ManualsBrandsSENA TECHNOLOGIES ManualsElectronicsSnowTalk2

Snowtalk2 Manual

Charging

Red LED: Charging

Blue LED: Fully charged

Power On/Off

Power On : Press and hold the (+) Button and (-) Button for 1 second

Power Off : Tap the (+) Button and (-) Button.

Volume Adjustment

(+) Button - Increase the volume

(-) Button - Decrease the volume

Summary of content (6 pages)

PAGE 1
Snowtalk2 Manual Charging Red LED: Charging Blue LED: Fully charged Power On/Off Power On : Press and hold the (+) Button and (-) Button for 1 second Power Off : Tap the (+) Button and (-) Button.
PAGE 2
Battery Check Phone, Music Pairing Initially Pairing the headset The headset will automatically enter the phone pairing mode when you initially turn on the headset or in the following situation: • Rebooting after executing Factory Reset 1. Press the (+) Button and (-) Button. 1. Search for Bluetooth devices on your mobile phone. Select the Snowtalk2 in the list of the devices detected on the mobile phone. 2. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
PAGE 3
Voice dial: Press the (R) for 3 seconds. Speed dial: Press the (+) Button for 3 seconds. Rejecting a call: Press the (+) Button for 2 seconds. Intercom Intercom Pairing 1. Press and hold the (R) Button of two headsets for 5 seconds until red LEDs of both units start to flash rapidly. 2. Simply tap the (R) Button of any one of the two headsets. Intercom Start/End : Tap the (R) Button .
PAGE 4
Certification and Safety Approvals FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules.
PAGE 5
FCC Caution Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment. Certification et homologation de sécurité Déclaration de conformité FCC Cet appareil est en conformité avec la partie 15 des règles de la FCC.
PAGE 6
particulière. Si cet équipement génère des interférences nuisibles à la réception de la radio ou de la télévision (ce qu’il est possible de déterminer en mettant l’équipement hors tension, puis sous tension), l’utilisateur est invité à suivre une ou plusieurs des mesures suivantes pour corriger le problème des interférences en prenant l’une des mesures suivantes : -Modifier l’emplacement ou l’orientation de l’antenne de réception. -É loigner l’appareil du récepteur.