User's Manual

Bluetooth Interface Board User’s Manual

Features

The Bluetooth Interface board has the following features:

1) A built-in Bluetooth module

2) Bluetooth 2.1+EDR compatible

3) Power class: Class 2

4) External dimensions: 50 mm × 70 mm

Manufacturer: Seiko Epson Corporation

Model Name: M224B

Product Name: Bluetooth Interface board for printer

Integration to the end product

The Bluetooth Interface Board has to be installed and used in accordance with the technical

description/installation instructions provided by the manufacturer.

The system may only be implemented in the configuration that was authorized. Note that

any changes or modifications to this equipment not expressly approved by the manufacturer

could void the user’s authority to operate this equipment.

Regulatory Information

USA-Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy. If not installed and used in

accordance with the instructions, it may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

PAGE 1
Bluetooth Interface Board User’s Manual Features The Bluetooth Interface board has the following features: 1) A built-in Bluetooth module 2) Bluetooth 2.
PAGE 2
If this equipment does cause harmful interference to radio or television reception, which can be determined by tuning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the distance between the equipment and the receiver. -Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
PAGE 3
Canada-Industry Canada (IC) This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
PAGE 4
Labelling The Bluetooth Interface board labelled as below. IC: 1052C-M224B The proposed IC ID label format is to be placed on the module. If IC ID is not visible when the module is installed into the system, “Contains IC: 1052C-M224B” shall be placed on the outside of final host system.