User's Manual

Bluetooth Interface Board User’s Manual

Features

The Bluetooth Interface board has the following features:

1) A built-in Bluetooth module

2) Bluetooth 2.1+EDR compatible

3) Power class: Class 2

4) External dimensions: 66 mm × 88 mm (aerial cover included)

Manufacturer: Seiko Epson Corporation

Model Name: M212B

Product Name: Bluetooth Interface board for POS printer

The antenna used this module is as follows;

Antenna Type: CHIP ANTENNA

Antenna Gain: 2 dBi

Integration to the end product

The Bluetooth Interface Board has to be installed and used in accordance with the technical

description/installation instructions provided by the manufacturer.

This Bluetooth interface board is exclusively for EPSON TM printers with a

slot dedicated for it. No devices other than EPSON TM printers can use

this.

The Bluetooth Interface Board is listed as a Limited Modular Transmitter device because its

radio elements don’t have its own shielding. Therefore, when it is installed in the printer, be

sure to push the board fully into the slot.

Note that any changes or modifications to this equipment not expressly approved by the

manufacturer could void the user’s authority to operate this equipment.

PAGE 1
Bluetooth Interface Board User’s Manual Features The Bluetooth Interface board has the following features: 1) A built-in Bluetooth module 2) Bluetooth 2.
PAGE 2
Regulatory Information USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
PAGE 3
Caution: Exposure to Radio Frequency Radiation. To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjunction with any other antenna or transmitter. Canada-Industry Canada (IC) This device complies with RSS 210 of Industry Canada.