NF05675-1.
11. ACCESORIES Power Cord Wireless Microphone (optional) User Manual Battery (optional) Power Adapter FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2.
2 3. CONTROL ELEMENTS 3 4. RECEIVER (RX) OPTIONAL 7 5. TRANSMITTER (TX) 8 6. CABINET POSITIONS 12 7. CONNECTING DIAGRAM 13 8. WIRE CONNECTIONS 15 9. TECHNICAL SPECIFICATIONS 16 10. BLOCK DIAGRAM 17 11. ACCESSORIES 18 12. CAUTION 18 MIXOUT 2. FEATURES DC IN 1 FULL 1. IMPORTANT SAFETY INFORMATION SPK 10.
9. TECHNICAL SPECIFICATIONS 5” All-In One PA system AC: 100-240V~50-60Hz(when using supplied ac adapter DC24V 2.5A) / Battery: 14.8V(Lithium) 5.25" 80Hz-16KHz 113dB MAX Class D 40W Low Battery Level Indicators. 5 UHF 470 ~960 and 20 258mm(L) x 192mm(W) x 211mm(H) 3.4Kg 1.
FEATURES 8.WIRE CONNECTIONS sound system 40W RMS 5.25 113dB MAX SPL 5 CH1 (optional) 14.
CONTROL ELEMENTS 1 4 7 13 8 17 14 2 9 5 15 11 16 3 AC adaptor 6 10 19 20 12 21 28 AC adaptor 14 22 27 23 24 26 25 18
7.CONNECTING DIAGRAM 1 2 3 4 5 6 7 8 9 10 12 speaker or to add a sub-bass.
14 6.CABINET POSITIONS 15 16) Low battery Indiccator When the Low Battery lights up, it means that the battery is about to run out. Please connect the AC Power adapter to charge the battery in time. 17 18 DC IN Plug the supplied AC adaptor into the DC IN to charge the batteries.The adaptor can also be used as the power supply.
How to pair your receiver and transmitter Power on you receiver, press and release the UP or DOWN button to select the channel code you perfect manually, Then press and hold the UP button to enter pairing mode, while press and hold DOWN button, it not only enters pairing mode but also find the cleanest channel by automatic scanning. Power on your transmitter, Then place the IR port o receiver to face towards the IR lens of transmitter within 20 CM distance. Once TX and RX are paired successfully.
4. RECEIVER(RX)OPTIONAL 1. SET button: press and release the button to switch interface from CH to volume. Enter CH interface, digital light ( only figure 8 )will light up. Enter Volume interface, digital light (both figure 8 and decimal point) will light up simultaneously. 2. UP button: under CH interface, press and release the button to increase channel code number. you can select the channel you perfect .
5.