SN SHOWS Is © registered trademark of SEAR TECHNICIAN, GROUP LIMITED rr SEIKO TECHNICAL GROUP LIMITED NOI LANE 17, SEC, HAN SHI WEST ROAD, TAICHUNG 40151, TAIWAN tel: 886-4-22313737 fac B04-4-22346757 i.
Safety Related Symbols A This symbol, wherever used, alerts you to the presence of insulated and dangerous voltages within the Product enclosure. These are voltages that may be sufficient to constitute the risk of electric shack or death CAUTION This symbol, wherever used, alerts you ta important ‘operating and maintenance instructions. Please read. Protective Ground Terminal Almanacs {Alternating Current) AC mains {Incarnating Current) Denotes the product is muted on. Denotes the products tuned off.
Mode! WAN-2 Power Supply DC 5V/1A Consumption Current <300mA |Operating Temperature [0 ~ 557 Storage Temperature -20 ~ +80°C Frequency 2412MHz-2472MHz Receive Sensitivity -84dBm{Min} [Output Level bedbug Frequency Response 20 ~ S/N >85dB [Dynamic Rangefinder >85dB [Crosshatch >90dB [THANT <0.
1 Introduction 5 2 Features feature s Wireless Music 3 Control Elements — 6 Toi 4 Connection Mode 7 sap mode 7 stampede 8 10 Nisan psn linen Cie Testis bis Ss TARA be ey Sut ip successfully, Restarting i How to use: Connect mobile phone/tablet PC to the router that the connected WAN-2 Is In. Other steps can be referred to the use under AP mode.
How to connect: 1) Open the website on the PC or the cellphone In the AP mode, Input the hit: //192 168.0. then you can set the Device Information. glide dusts Nerd RARER TTR Si bi tas wa gas ie Fuss ica si Ca aaa Tie Fi adi a EEE Hen 2) Select the router to be connected by module in wireless network name and type in the network password . After configuring, click the button bi and restart the WAN-2. If It Is successfully,you can see “Set up successfully, Restarting...
INS Front B Resistances ® Audio Output Connector Connector for output signal @ Antenna for Receiver Receive signals from the transmitter. To receive the signal better, please make sure the antenna Is not sheltered. @aAP LED The AP LED will light up when WAN-2 is on AP mode @mm Ode Press and hold MODE button about 3 seconds stopwatch AP mode or STA mode ® LEVEL Adjust WAN-2 output volume by LEVEL knob.