MBETAMANUALL3ZA FINAL 200544 1016 Installation Tips & Recommendations 1-1, Please be careful not to lock yourself out. Please lower the glass windows before you start the installation in case the door locks with the key inside. Also, meal the remote to the brain module after the installation has been completed 1-2. Use Digital Multi meter for testing Use a Digital Multi meter for all testing of wires in the vehicle.
ME61AMANUALOZZ FINAL 200544 1017 AM T[9%] (Red) : ()12V Input no Hollow /Black Non Yellow (Brock Solder this wire to the vehicle's 12V constant. This wire must be supplied power all fe Yalow ts com Yellow of the time and must be able to withstand high current draw. Yellow [White No Yellow 1 White Green / Black Green /Black for parking Lock com oj Omen Look] com Flamenco Positive parking it output k ° Green/White No.
MBETAMANUALL3ZA FINAL 200544 1017 Method 3 : External Actuator +12V (CON-1 Red) Hl Teletext Green /Black Actuator mo re [ Green {White 7 < External Actuator> No 1 (Green) : (+12 it ion This wire will test {using your digital multi-meter} OV with the key off, and 12V with the key in the ‘ON or RUN’ position No 2 (Blue) : Negative Starter-Kill Please use the per-wired starter kill relay. Statutorily Mode Anti Jacking Mode ..
MBETAMANUALL324 FINAL 200544 10:17 AM TF] 17 No7 (Black /White) : Input for optional Sensor When installing additional sensors, use this wire as the input wire for those sensors. Ways remember, when attaching more than one sensor fo any input, you must diode isomer them so they they sort bactericide ink each other. When Magi car systems are installed, please pay attention to stretch out the wire of antenna.
MBETAMANUALL3ZA FINAL 200544 1017 AMT} 3] 19 Err LET You can only program one option at a time. You will have to repeat the procedure for every option you would like to change. Step: Press buttons («s+ 49) for 2 seconds. The siren and signal lights will chirp and flash one time each. If you fail to program, the siren and signal lights will chirp and flash three times each. Step: Press bunion #6 the number of mes fo go to the option number you want to change.