User's Manual

Pairing to Your Device
To pair to your phone or device for the first
time hold down the play button located on
a red and blue flashing light. Open your
settings on your phone or device.
You will see the name "Musical Headwear"
If a password is requested please use the default: 0000
Next time you switch on your product, it will be connected
automatically.
Taking Calls
To take an incoming call press the Play/Pause button. If you
are listening to music it will automatically stop. To end a call
Select your music as normal from your phone or device.
Use the buttons on your control panel to Play-Pause & Skip
tracks.
Power On
Simply hold down the Play/Pause button for 4 seconds to
turn on.
Power Off
Simply hold down the Play/Pause button for 4 seconds to
turn off.
USER MANUAL
Could activate SIRI on iOS device for commands
Headphones are Removable for Headwear Washing
Product is Rechargeable Through Universal Micro-USB Cable
DO NOT Expose Product Liquids or Moisture
DO NOT Attempt to Tamper with Product By Dropping, Disassembling,
Opening or Scratching, etc
Take Out the Headphones Before Washing
Keep the Product Away From Fire
DO NOT Store the Product Near Acidic or Alkaline Material
1 2
3
4
Volume Down (long press) / Previous Song (short press)
1
Play/Pause/Answer/Hang Off/Redial
Power On/Power Off (long press)
Play/Pause (short press)
Answer/Hang Off (short press)
Redial (double click)
2
Volume Up (long press) / Next Song (short press)
3
4
LED Status Light
Precautions
Features
Instructions
USB Charging
Port
Fully charge battery before first use.
Use the supplied USB cable, simply plug into
the charging port of the headwear.
Now plug the other end of the USB cable into
your PC or laptop.
During charging, the LED Status Light will turns
to be red on the control panel.
When charging is completed, the red light will change to blue.
It will take about two hours to get the battery full charged.
Charging Instructions
Buttons Interface
Made in China
press the Play/Pause button. Double click the Play/Pause
button will re-dial the last number.
Built-in Microphone for Hands Free Talking
Specifications
Frequency: 2.402 GHz-2.480 GHz
Transmission Range: 20M / 66Ft
Speaker Unit: 24Ω/30mm
Battery: 3.7V 100mAh Rechargeable Li-polymer Battery
Standby Time: Over 260 Hours
Play Time: 6 Hours
Charge Time: DC 5V Approx 120 Minutes
With Over-Current, Overcharge & Overheat Circuit Protection Design
on PCB
-Double click button “+” to activate SIRI on iSO device
the control panel for 4 seconds until you see
in the list, select it and your device will be
-Wireless Headphone will shut down if connection failed in
3 minutes.
-Long press Play/Pause button for 2 seconds to reject a
incoming call.
Playing Music
connected.
Built-in Wireless Headphones
for Your Music and Calls
Musi cal Hea dw ear
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Warnings
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.