Bluetooth Speaker Phone Bluetooth Speaker Phone User s Manual ●Be sure to read this user manual before using the VISOR. ●Please keep this manual as it may be useful later.
Features Contents I Supports both handsfree & headset VISOR can be used as a handsfree unit or headset as the situation demands. I Crystal clear tone quality I LCD display You can view battery, volume and call status at a glance.
Part description Front Internal Mic.
Button functions Configuration For the best results, fully charge the battery prior to initial use. How to use button Supporting profile Handsfree Headset - Hold Y Y Last number called - Press Y Y Voice dialing(provided the phone supports this) - Hold Y N Number dialing - Dial the number then Y N Speed dialing - Hold the Speed dial number (press the last digit longer).
Configuration Mounting on the sunvisor 2 Place it on the sunvisor in a car. Press and hold END & Power button for more than 3 seconds. Preparation 1 Fix the sunvisor clip into the back fixing groove. Power on ●Power turns on. Power off ●Position the microphone towards the driver. Slide the mic down to get clearer sound. ●Power turns off. How to use Using Mic. Press and hold END & Power button for more than 3 seconds. Volume control Slide the volume controller up or down.
Handset compatibility Pairing with a Bluetooth mobile phone Functionality varies according to handset. First, check to see if the handset supports handsfree profile or headset profile. After pairing the Bluetooth mobile phone with VISOR you can use it as a handsfree unit.
Making a call Last number/Voice dialing You can make conversation with a speaker phone and use it as a handsfree unit. 1 Dial the number buttons to make a call to specific number. 2 Press SEND. ●The call will be made. Preparation Number dialing You can make number dialing only provided that your mobile phone supports handsfree profile. Press SEND button. ●By pressing this button the last number dialed will be called. (In the case of SonyEricsson handset, voice dialing initiates.
Answering/Rejecting a call/ Transferring audio Upgrading the firmware Additional features may be added through new firmware revisions. Answering a call Preparation When ringing VISOR will play a melody and the blue LED will flash. When ringing press SEND button. ●You can make conversation through the speaker phone. Rejecting a call When ringing press END & Power button. Connect the Visor and PC by using the upgrading cable. Make sure that the charger should be connected to the Visor first.
Troubleshooting Precautions ▶ Charge the battery. Check if the battery inserted properly. ▶ Remove the battery and Check if the dust exists in the outlet of charging jack. ▶ Remove the dust and connect Check if END & Power button was not pressed long enough. ▶ Press END & Power button Check if the handset supports handsfree profile. ▶ In order to make conversation with Check if the battery of the VISOR is low. ▶ Charge the battery. Can not pair VISOR with the Bluetooth device.
Specifications Description Ear Phone Interface Ear Phone Type(Nokia) Battery 3.6V, 950mA Li-Ion Speaker 8Ω/1.5W(Normal) MIC -47 +/- 1.5dB Power Consumption Max 250mA Cigar Lighter Jack OUT : 5.0V/800mA 5.0V/1A 2400MHz to 2483.5MHz(USA, Europe) Modulation Method GFSK, 1Mbps, 0.5BT Gaussian Transmission Power Typ. 1.0 dBm Hopping 1600hops/sec, 1MHz channel space Rx. Sensitivity Typ. -83.
