User Instructions

INSTRUCTIONS

RIDGE REMOTE (433 MHZ)

Model 14-R433

1 of 2

IN THE BOX

Make sure you have everything shown here.

This remote must be paired to and used

with a Security Brands Ridge 2.0 Transceiver

(Model 14-REC20) to work correctly.

Ridge Remote Visor Clip

Button 1

LED

PROG LED

PROGRAMMING PAIR

Button

Button 2

WHAT’S WHAT

The Ridge Remote has two programmable buttons and

a status LED. Each button can be paired to a separate

modes of operation.

BASIC SETUP

1. On Ridge 2.0 Transceiver, hold down

PROGRAMMING PAIR button for three seconds

and release. PROG LED will light up.

NOTE: The transceiver must be powered up and

have its cover removed for this step. Please see the

instructions that came with it for help.

2. On Ridge Remote, press and hold down both

buttons and pay attention to remote LED.

PAGE 1
INSTRUCTIONS RIDGE REMOTE (433 MHZ) Model 14-R433 IN THE BOX Make sure you have everything shown here. This remote must be paired to and used with a Security Brands Ridge 2.0 Transceiver (Model 14-REC20) to work correctly. Ridge Remote Visor Clip WHAT’S WHAT LED The Ridge Remote has two programmable buttons and a status LED. Each button can be paired to a separate Button 1 modes of operation. Button 2 BASIC SETUP 1. On Ridge 2.
PAGE 2
INSTRUCTIONS 3. 4. RIDGE REMOTE (433 MHZ) Model 14-R433 you want to program and release other button. now programmed. 5. Repeat procedure for second button if desired. NOTE: The second button can be paired with the Step 3 Step 4 MODE SELECTION (MOMENTARY/LATCH) 1. On Ridge Remote, press and hold down both buttons and pay attention to remote LED. 2. 3. buttons. both Go to securitybrandsinc.com/ridge/ more helpful resources.
PAGE 3
FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.