500-24080, Rev 4
500-24080, Rev 4
500-24080, Rev 4
500-24080, Rev 4
• • 5 500-24080, Rev 4
• • Figure 2.
500-24080, Rev 4
3/8” diameter (Metal) 1/2” or 5/8” diameter hole, as applicable, is centered at least 5/16” from the end (see Figure 6, “Position of Wire Feed-Through Holes”).
500-24080, Rev 4
500-24080, Rev 4
Template Pins Strike Plate Housing 11 500-24080, Rev 4
6x 6-32 12 500-24080, Rev 4
3/16” diameter 13 500-24080, Rev 4
Template Pins Strike Plate Housing 14 500-24080, Rev 4
500-24080, Rev 4
1. 2. 3. 4. 5.
6.
500-24080, Rev 4
500-24080, Rev 4
500-24080, Rev 4
1. 1.
1. 2.
1.
2. 1.
1.
5. 6. 7.
500-24080, Rev 4
500-24080, Rev 4
