User's Manual

ManualsBrandsSecurifi ManualsElectronicsAlmond Click

AlmondClickQSG SC1

1. LEDindicator

2. Pushbutton

3. CR2032battery

4. Join/Reset/Tamperbutton

5. Lanyardholeandgroove

English

AddinganAlmondClick

Step1:Removethebackcoverbypullingthebackcoverupwardsatthegrooveprovidedin

thelanyardhole.

Step2:Tapthe“AddSensors”iconontheLCDUIofyourAlmondrouterandtapon“Add”to

starttheaddingprocess.

Step2:Pressthejoin/resetbuttononthebackoftheAlmondClick.

Step3:InsertthebatteryintothebatteryholderonthebackoftheAlmondClickwhilethe

join/resetbuttoniskeptpressed.TheLEDindicatoronthefrontwillstartblinking.This

indicatesthattheAlmondClickisbeingaddedtoyourAlmondrouter.

Step4:WaitfortheAlmondroutertofinishaddingtheAlmondClick.Youwillseeamessage

thatthesensorhasbeenadded.Enteranameandlocationforthesensorandtapon

“Done”.

Step5:SnapthebackcoverontotheAlmondClick.Makesurethatthelanyardholesinthe

bodyoftheAlmondClickandthebackcoverarelinedup.

Step6:OntheAlmondLCD,gobacktothe“Home”screenandtapon“ConnectedSensors”

andtaponthesensoryoujustadded.Nexttapon“Tampered”toresetthetamperswitch.

Summary of content (4 pages)

PAGE 1
Almond Click QSG 1. 2. 3. 4. 5. SC1 LED indicator Push button CR 2032 battery Join/Reset/Tamper button Lanyard hole and groove English Adding an Almond Click Step 1: Remove the back cover by pulling the back cover upwards at the groove provided in the lanyard hole. Step 2: Tap the “Add Sensors” icon on the LCD UI of your Almond router and tap on “Add” to start the adding process. Step 2: Press the join/reset button on the back of the Almond Click.
PAGE 2
Your sensor should now be fully operational. Click the push button once and and twice to see “One Press” and “Two Press” on the Almond LCD. Resetting and Almond Click To reset the Almond Click, remove the back cover and remove the battery from the battery holder. Wait for 10 seconds, and then reinsert the battery while the Join/Reset switch is pressed. The LED indicator on the front of the Almond Click will start blinking, and the reset process will be complete once the LED stops blinking.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
This device and its antenna(s) must not be colocated or operation in conjunction with any other antenna or transmitter. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.