User's Manual

ManualsBrandsSecurifi ManualsElectronicsPeanut Plug

Peanut Plug - Quick Start Guide

MODEL : PP1-WHT-US

Adding to Almond

1. Peanut Plugs must be added one at a time.

2. Insert the Plug into a power outlet. If the LED is not blinking, Reset the Plug as per below instructions and

then start over from Step1.

3. On the Almond touchscreen, tap the Add Sensor icon and then tap Add. The touchscreen should now

display the message “Adding sensor…”

Resetting the Peanut Plug

Reset the Plug by pressing the pairing button (<Button Symbol>) for 10 seconds and then releasing it.

Remove the Plug from the power outlet and plug it back in.

Monitoring & Controlling the Plug

1. The Toggle button (<Button Symbol>) on the Plug can be used to manually switch the plug and its attached

appliance on and off.

2. The Plug can also be monitored and controlled via the Internet using our free Almond iPhone and Android

apps or from a standard web browser (http://connect.securifi.com).

3. In case the Almond can’t access the Internet, you can also monitor the Peanut Plug via the Connected

Home app on the Almond’s touchscreen or via the Almond’s local web user interface (default:

http://10.10.10.254)

Operating Conditions

Indoor Use Only

Temperature: 0 to 40C (32 to 104F)

Humidity: 0 to 80%

Altitude: Up to 2000m (6500 ft)

Caution

1. Make sure the Peanut Plug is OFF before plugging an electric appliance into it.

2. Unauthorized changes or modifications to the Peanut Plug will void its warranty and could seriously

compromise its safety or efficacy.

3. Protective earthing: Ground pin must not be removed from the device.

4. Make sure an active Peanut Plug is easily accessible and can be disconnected quickly.

5. Unplug device prior to cleaning. Use dry cloth on exterior of the device. To avoid shock hazard and/or

damage to device, DO NOT use any liquid solution.

6. Install and use Peanut Plug in accordance with the appropriate Electrical Codes and Regulations

7. Do not install near heat sources or in humid areas

8. When operating under heavy loads, the Peanut Plug may heat up considerably. Allow it to cool before

manually removing it from an electrical outlet.

Summary of content (4 pages)

PAGE 1
Peanut Plug - Quick Start Guide MODEL : PP1-WHT-US Adding to Almond 1. Peanut Plugs must be added one at a time. 2. Insert the Plug into a power outlet. If the LED is not blinking, Reset the Plug as per below instructions and then start over from Step1. 3. On the Almond touchscreen, tap the Add Sensor icon and then tap Add.
PAGE 2
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
PAGE 4
NCC Warning Statement Article 12 Without permission, any company, firm or user shall not alter the frequency, increase the power, or change the characteristics and functions of the original design of the certified lower power frequency electric machinery.