OKO 3MP DOORBELL CAMERA Quick Start Guide POWERED BY DB3A
Getting to know the camera MOUNTING HOLES MicroSD CARD SLOT TERMINALS RESET BUTTON STATUS INDICATOR LENS + Flashing blue: the camera is on and ready for Wi-Fi connection + Steady blue: the camera is running properly + Steady red: the camera is starting + Flashing red: there is a network connection issue PIR MOTION DETECTOR STATUS INDICATOR CALL BUTTON
What’s in the box? 1 2 DOORBELL CAMERA 4 3 MOUNTING PLATES & PLATE FOAM ADDITIONAL FACEPLATE POWER KIT & WIRE HARNESS 5 6 FUSE WIRE 7 SCREWDRIVER 8 U-SHAPED WIRES DRILL BIT & MINI-LEVEL 9 WIRE CONNECTORS 12 SECURITY SCREWS 10 MOUNTING SCREWS 13 FIXING SCREWS 11 ANCHORS 14 DOORBELL SCREWS
Installing the chime power kit Requires an existing mechanical chime or a digital chime with TRANS and FRONT terminals Locate your AC mains power box and switch off the circuit breaker to your existing doorbell and chime. Test your existing doorbell to confirm the power is off. The chime should not ring if the power is disconnected. Remove the cover from the chime box. Locate the terminals labeled TRANS and FRONT. Loosen the screws and disconnect both wires.
Wire the MID-POINT “V” part of the WHITE wire to the FRONT terminal and tighten the screw to secure it. Wire the MID-POINT “V” of the BLACK wire to the TRANS terminal and tighten the screw to secure. Connect the END of the WHITE wire to the original FRONT wire, twisting a wire connector cap onto the two wires to secure them together. Connect the END of the BLACK wire to the original TRANS wire and twist together with a wire connector cap.
Mounting the doorbell camera If replacing an existing doorbell, ensure the AC power is off, then unscrew the doorbell from the wall. Unscrew the two terminals to release both wires. The recommended installation height is 4ft (1.2m) above the ground. Select the mounting plate that provides the best viewing angle for the doorbell. If mounting to an uneven surface use the included plate foam to remove any gaps between the mounting plate and wall.
Wiring the doorbell camera If you have a chime installed, follow option A; if not, follow option B. OPTION A In your doorbell accessories, locate the two “U” shaped extension wires. Attach the opposite ends of both “U” wires to each of the existing doorbell wires. Twist both sets of wires together with wire connector caps. Connect the “U” end of each “U” wire to the terminals on the back of the doorbell. Tighten into place with the fixing screws.
Remove the faceplate from the doorbell camera by pulling out from the bottom edge. (Optional) Insert a MicroSD card into the MicroSD card slot on the side of the camera. The card will be formatted during the add camera process. Tuck the wiring into the recessed gap in the center of the mounting plate and wall, then place the doorbell camera in position on the mounting plate. Insert the two doorbell screws into the mounting holes in the doorbell and tighten to fix the doorbell to the mounting plate.
Turn the AC power back on at the mains power box. The doorbell camera will power up and is ready to add in the app. Connecting to the camera In the app, go to the Video or Settings > Video settings page and tap the circular “+” button to launch the camera installation wizard. Follow the instructions in the app to connect the camera to your account and configure the network settings.