User's Manual

ManualsBrandsSecure Wireless ManualsElectronicsWireless Recess Door/Window Sensor

Secure Wireless Model SW-xxx-V2, VANISHING 2, DOOR/WINDOW DEVICE

Description

The Secure Wireless model number SW-xxx-V2 Vanishing 2 device is a

fully supervised, tamper-protected door/window transmitter that works with

the xxx receiver. It is designed to be installed with its integral magnet on

most doors or windows and includes a radio transmitter that sends

information to the receiver. Opening the door or window will cause the radio

transmitter to send an alarm report. Closing the door or window will cause the

radio transmitter to send a restore code that indicates that the door or window is

closed. If the case of the SW-xxx-V2 is removed for any reason, the radio

transmitter will send a tamper alert to the receiver. Should the battery voltage

drop below a prescribed level the SW-xxx-V2 will send a low battery report

indicating that the devices battery requires changing. (Consult the “installing the

battery” section for information about changing the battery.)

Locating the Transmitter

For Door Installation: Select the location where the SW-xxx-V2 is to be mounted.

The transmitter should be located vertically on the door jam or more than six

inches of the top of the door. The integral magnet should be mounted on the

door, within ½ inch of the transmitter with the notch on the magnet aligned with

the middle notch on the transmitter as shown on Figure C.

For Window Installation: Select the location where the SW-xxx-

V2 is to be located. Mount the transmitter on the window jam

near the top of the section of the window to be protected. The

integral magnet should be mounted on the window, within ½

inch of the transmitter with the notch on the magnet aligned

with the middle notch on the transmitter as shown on Figure C.

Mounting the Transmitter

1. Use the base of the sensor as a template and mark the mounting holes

with a pencil.

2. Drill the holes for the screws, 5/16” drill size

3. Mount the base to the door jam with the screws provided.

Summary of content (4 pages)

PAGE 1
Secure Wireless Model SW-xxx-V2, VANISHING 2, DOOR/WINDOW DEVICE Description The Secure Wireless model number SW-xxx-V2 Vanishing 2 device is a fully supervised, tamper-protected door/window transmitter that works with the xxx receiver. It is designed to be installed with its integral magnet on most doors or windows and includes a radio transmitter that sends information to the receiver. Opening the door or window will cause the radio transmitter to send an alarm report.
PAGE 2
a. For doors that open on the left hand side, the round battery cavity in the base should be at top when the base is mounted to the door jam. b. For doors that open on the right hand side, the round battery cavity in the base should be at the bottom when the base is mounted to the door jam. 4. Carefully replace the sensor on the base by aligning the tamper switch with the plastic tamper tab (Figure 1) and snap the cover down on the base. The accessory package also includes self adhesive tape.
PAGE 3
Verifying the programming and RF communications (Per customer requirements) Case Tamper Detection Removing the cover of the SW-xxx-V2 will cause the integral transmitter to send a case tamper report to the receiver. This tamper condition will remain on the system until the case cover is reinstalled and the integral transmitter sends a tamper restore to the receiver. General Specifications Operating Temperature: Operating Rel.
PAGE 4
1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. Conformité Réglementaire Ce dispositif est conforme à la réglementation de la IC et (Partie 15) de la FCC.