User's Manual

Quick Start
RemoteTunes
TM
with
Dock Connector
iPod® is a trademark of Apple Computer, Inc. registered in the US and other countries
Features and specifications are subject to change without notice. All trademarks and registered trademarks are the property of their
respective owners. © 2006, Targus Group International, Inc. and Targus, Inc.
Introduction
Congratulations on purchasing Targus RemoteTunes with Dock Connector. This device gives up to 150 feet wireless control of your
iPod ® within your home or on the go. The compact, lightweight remote design is perfect for mobile users. You can charge your iPod
by using the dock connector so the iPod will never be low on battery.
List of Contents
• RemoteTunes Remote • Receiver
• Belt Clip • 3 foot RCA cable
CAUTION : Using an incompatible accessory
with your iPod products could lead to its
damage or malfunction.
AER02US 400-0324-001A
Receiver
Operating Instructions
iPod RF receiver setup:
Plug RemoteTunes into the dock connector located on the bottom of your iPod
and WAIT 30 seconds. A self-diagnostic will automatically run and your
wireless remote will be ready for operation once the process is complete. To
sync or charge the iPod, simply plug your charging cable into the bottom of the
RemoteTunes receiver while it’s connected to the iPod.
Advanced Low Power Mode (ALPM):
RemoteTunes uses an advanced power down mode which minimises current draw on your
iPod battery if you are not connected to a constant power source. After 20 minutes of
sensing no music playing or no remote commands being sent, the RemoteTunes goes into
a battery saving mode. The RemoteTunes receiver will automatically re-power itself when it
detects music playing or when a remote button is pressed for more than 0.6 seconds.
Pair up to 10 RemoteTunes remote with any RemoteTunes receiver.
Pairing instructions:
1) Unplug the RemoteTunes receiver from your iPod.
2) Make sure your iPod is sufficiently charged.
3) Plug the RemoteTunes receiver into the iPod dock connector.
4) Within the 30 seconds of step 3, simultaneously press and hold, for 3 seconds, the Vol. +, Vol. -,
forward and rewind buttons.
5) The remote has been paired.
Extra Features
Enjoy your favourite music from your
stereo system by using the RCA cable.
Simply plug the 3.5mm headphone jack
to your iPod and connect the RCA jacks to
your stereo’s audio inputs.
Using the RCA cable
iPod with
video
iPod
mini
iPod
4G
iPod
3G*
Remote Control Function
Rewind: Press and
release this button to move to
the previous track. Press and
HOLD this button to rewind
through the track
Playlist: Press and release this
button to activate the playlist mode.
The LED on the remote will begin to
flash very quickly, while it flashes
(approximately 5 seconds) move
through playlists using the Rewind
and Forward buttons.
* Playlist function is not compatible
with the 3G version of the iPod.
Volume Down: Press
and HOLD this button to
scroll volume down.
Volume Up: Press and
HOLD this button to scroll
volume up.
Forward: Press and release this
button to move to the next track.
Press and HOLD this button to
forward through the track.
Shuffle: Press and
release to toggle between
shuffle on/off .
* Shuffle function is not
compatible with the 3G
version of the iPod.
Play/Pause/Sleep: Press
and release to toggle between Pause
and Play. Press and HOLD for 2 full
seconds to put the iPod into sleep
mode. You press and hold this button
for longer than 1 second but less than
2 seconds the RemoteTunes will
ignore your request.
Remote control
+
-
Features and specifications subject to change without notice. All trademarks and registered trademarks are the property of their
respective owners. © 2006 Targus Group International, Inc. and Targus Group (UK) Ltd.
iPod
photo