User's Manual

ManualsBrandsSecure Wireless ManualsElectronicsWireless Garage Door Sensor/Tilt

Description

The AT&T model number SW-ATT-TILT Garage Door Sensor is a fully

supervised tamper protected sensor that will monitor the opening and closing

of a garage door installed in the Digital Life System. It is designed to be

mounted on the top section of a sectional garage door. Once the garage door

is opened to a minimum angle of 45 degrees the sensor will initiate an alarm

(or garage door open) condition. System programming will determine what

actions this condition will provide on the system. The sensor will also send a

restore (or garage door closed) condition when the tamper switch is returned

to a position where the angle is less than 45 degrees. If the case of the SW-

ATT-TILT is removed for any reason, the radio transmitter will send a tamper

alert to the Digital Life Controller. Should the battery voltage drop below a

prescribed level, the SW-ATT-TILT will send a low battery report indicating

that the battery requires changing. (Consult the “installing the battery” section

for information about changing the battery.)

Installing the Battery

When the system indicates the sensor battery is low, replace it immediately.

Use the recommended replacement batteries (See specification) or contact

AT&T technical support for more information.

To replace the battery, do the following:

1. To remove the sensor cover from

the base, press a flathead

screwdriver into the slot on the

bottom of the sensor (Figure 1)

and turn the screwdriver 90

degrees.

2. Place a small flathead screwdriver

in the slot between the metal clip

and the battery and twist the

screwdriver slightly while holding

back one of the black plastic

edges holding the battery.

Dispose of the battery as required by local laws.

3. Insert the replacement battery with the + sign facing up.

Summary of content (4 pages)

PAGE 1
Description The AT&T model number SW-ATT-TILT Garage Door Sensor is a fully supervised tamper protected sensor that will monitor the opening and closing of a garage door installed in the Digital Life System. It is designed to be mounted on the top section of a sectional garage door. Once the garage door is opened to a minimum angle of 45 degrees the sensor will initiate an alarm (or garage door open) condition. System programming will determine what actions this condition will provide on the system.
PAGE 2
4. Verify programming and RF communication with the Digital Life Controller. 5. Replace the sensor cover on the base. Align the tamper switch with the plastic tamper tap (See Figure 1) and snap the cover down on the base. Locating the Transmitter 1. For Sectional Door Installation: The transmitter should be mounted near the top of the top panel of the garage door. 2. Make sure that the tamper switch points to the floor. 3.
PAGE 3
Case Tamper Detection Removing the cover of the SW-ATT-TILT will cause the integral transmitter to send a case tamper report to the Digital Life Controller. This tamper condition will remain on the system until the case cover is reinstalled and the integral transmitter sends a tamper restore to the Digital Life Controller. IMPORTANT INFORMATION ABOUT RADIO DEVICES 1. AT&T radio controls provide a reliable communications link and fill an important need in portable wireless signaling.
PAGE 4
interférence reçue, y compris les interférences pouvant entraîner des conditions de fonctionnement indésirables. WARNING: The battery may explode if mistreated. Do not discharge, disassemble or dispose of in fire. Notice to users in California—CR Coin Cell Lithium Battery information: This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material—special handling may apply See www.dtsc.ca.gov.harardouswaste/perchlorate.