User's Manual

AT&T Model SW-ATT-RDW, RECESSED DOOR/WINDOW TRANSMITTER
Description
The AT&T model number SW-ATT-RDW is a fully supervised door/window
transmitter that reports to the Digital Life Controller. The detection portion of the
device is imbedded into the door or window frame while the integral magnet that
is imbedded into the door or window.
Opening the door or window will cause the radio transmitter to send an alarm
report. Closing the door or window will cause the radio transmitter to send a
restore code that indicates that the door or window is closed. Should the battery
voltage drop below a prescribed level the SW-ATT-RDW will send a low battery
report indicating that the devices battery requires changing. (Consult the
“installing the battery” section for information about changing the battery.)
Locating the Transmitter
For Door Installation: Select the location where the SW-ATT-RDW is to be
mounted. Two locations are preferred. The transmitter can be located in the top
portion of the door jam, near the side where the door opens, or it can be located
near the top of the door jam on the side where the door opens. The integral
magnet will be mounted in the door.
For Window Installation: Select the location where the SW-ATT-RDW is to be
located. Mount the transmitter in the window jam near the top of the section of
the window to be protected. The integral magnet should be mounted in the
window.
CAUTION: many windows may not accept the magnet which is
approximately 5/8 of an inch deep. Careful consideration should be given
before using the SW-ATT-RDW in a window application. Use the SW-ATT-
V2 in these applications.
CAUTION: do not use the SW-ATT-RDW if the door or window jams are
made of metal. The metal will severely limit the performance of the
transmitter portion of the device.

Summary of content (5 pages)