SECURE GROUP LAB OOD X1
CAUTION 1.Use careful with the earphone maybe possible excessive sound pressure from earphones and headphones can cause hearing loss 2. CAUTION : RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS 3. The product shall only be connected to a USB interface of version USB2.0 4. Adapter shall be installed near the equipment and shall be easily accessible 5. Operation temperature: -20-40°C. 6.
LTE FDD Band 1: 1920MHz~1980MHz LTE FDD Band 3: 1710MHz~1785MHz LTE FDD Band 7: 2500MHz~2570MHz LTE FDD Band 8: 880MHz~915MHz LTE FDD Band 20: 832MHz~862MHz LTE FDD Band 40: 2300MHz~2400MHz WiFi: 2412MHz~2472MHz (802.11b/802.11g/802.11n(HT20)) 2422MHz~2462MHz (802.11n(HT40)) Bluetooth/ BLE: 2402MHz~2480MHz GPS: 1575.42MHz FM: VHF band II: 87.5 MHz to 108 MHz GSM /WCDMA/LTE/WIFI and BT can be used in Europe without restriction.
EU Declaration of Conformity for Radio Equipment Directive (RED) 2014/53/EU SECURE GROUP LAB OOD hereby, declare that the essential requirements set out in the Radio Equipment Directive (RED) 2014/53/EU have been fully fulfilled on our product with indication below: Product Name: Smart phone Model / Brand Name: X1 Adapter Model: Y-5204C5020 Manufacturer :SHENZHEN GUANGYUANSHENG TECHNOLOGY CO., LTD. Input: 100-240Vac, 50/60Hz, 0.35A Output: DC 5.
EN 62368-1: 2014/A11:2017 And apply notified body assessment: Notified Body number 0700 PHOENIX TESTLAB GmbH Königswinkel 10 D-32825 Blomberg Germany Furthermore, the ISO requirement for the in-process quality control procedure as well as the manufacturing process has been reached. The technical document as well as the test reports will be kept for a period at least 10 years after the last product has been manufactured at the disposal of the relevant national authorities of any Member State for inspection.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.