SD-72081-6MQ Single-Gang Mortise Cylinder Key Switch Manual
ENFORCER Single-Gang Mortise Cylinder Key Switch Introduction: If a keypad or proximity card reader fails to activate an electronic lock, the user can switch between normally closed (N.C.) and normally open (N.O.) contacts using the SD-72081-6MQ, forcing the door to open. This acts as a backup for access control systems, so that the system does not rely on the integrity of a single device.
ENFORCER Single-Gang Mortise Cylinder Key Switch Installation: 1. 2. 3. 4. 5. Remove the back plate from the unit. Thread the cable wire through the electrical box and the center hole of the back plate. Connect the wires to the switch using the wiring diagram below. Fasten the back plate to the electrical box using the included mounting screws. Finish assembly by snapping the front cover onto the back plate.
ENFORCER Single-Gang Mortise Cylinder Key Switch Also Available from SECO-LARM: Flush-Mount Request-to-Exit Plate SD-7286-GWQ Indoor No-Touch Sensor SD-927PKC-NEQ Outdoor No-Touch Sensor with Manual Override SD-9263-KSVQ Mushroom Request-to-Exit Plate SD-7201GC-PEQ Illuminated Request-to-Exit Plate SD-7202GC-PEQ Piezoelectric Request-to-Exit Plate SD-6276-SS1Q For a complete listing of SECO-LARM products, please visit us online at www.seco-larm.com.