User Manual

ManualsBrandsSECO-LARM ManualsElectronicsIP/Ethernet Extenders

Manual

Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

IP / Ethernet Extenders

IPB-A1100Q*

Active IP Balun over Cat5e/6

IPB-A1200Q*

Active IP Balun over Coaxial

IPB-A1100Q

IPB-A1200Q

*Each set includes one transmitter and one receiver.

Front view

Rear view

Summary of content (4 pages)

PAGE 1
IP / Ethernet Extenders Manual IPB-A1100Q Rear view Front view Rear view Front view IPB-A1200Q IPB-A1100Q* Active IP Balun over Cat5e/6 IPB-A1200Q* Active IP Balun over Coaxial *Each set includes one transmitter and one receiver. Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.
PAGE 2
ENFORCER IP / Ethernet Extenders Introduction: ENFORCER Active IP Baluns are designed to extend the range of IP cameras or any TCP/IP device beyond the 300ft (100m) limit of Ethernet. The units do not filter out any protocols, codes, or applications, ensuring compatibility with any IP camera and its software.
PAGE 3
ENFORCER IP / Ethernet Extenders Installation: Rear panel connections IPB-A1100Q Rear panel connections IPB-A1200Q Set Tx/Rx DIP Switch Set Tx/Rx DIP Switch Connect Cat5e/6 cable between the receiver and transmitter Connect coax cable between the receiver and transmitter Front panel connections Both models Tx/Rx DIP Switch Positions Connect 5VDC Adapter Connect Cat5e/6 cable to a TCP/IP device. Each unit can act either as a transmitter (Tx) or a receiver (Rx).
PAGE 4
ENFORCER IP / Ethernet Extenders Troubleshooting IP device does not function correctly Make sure the balun is powered on both sides. Make sure the IP source and DVR or PC are powered. Test the coaxial or Cat5e/6 cable between the receiver and transmitter and make sure it is functional. Make sure that there are no problems with the IP device, cables, or DVR by plugging the IP device directly into the DVR or PC using the Cat5e/6 cables.