ASSEMBLY INSTRUCTIONS L SHAPED PLATFORM BED Be sure to check all packing materials carefully for small parts which may have come loose identify and count all parts and hardware. Compare with the parts list to be sure all parts are present. p “DO NOT TIGHTEN SCREWS : UNTIL COMPLETELY ASSEMBLED” SIZE OF MATTRESS AND FOUNDATION (SUPP This bed is designed to use a twin mattress ) and junkie board (374 x74 ). The total thickness must not exceed 8” inches.
ASSEMBLY INSTRUCTIONS L SHAPED PLATFORM BED Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Separate. Identify and count all pasts and hardware. Compare e parts list to be sure all parts are present.
Part List—WF281587 5 6 Bed side plate 3pc Bed side plate 1pc Bed board 24pc Front panel of trundle 1pc 27 28 Back panel of trundle 1pc
Part List—WF281588 4 14 Headboard cap -2pc Panel 2pc ER Drawer face plate 2pc Drawer back side plate 2pc 32 33 Drawer side plate 4pc Drawer bottom plate 2pc 34 — Bottom plate reinforcing strip 2pc
Part List—WF281589 1 2 CY Headboard 2pc Bed column 2pc 3 9 Bed column 2pe Left Front mid legs 1pc Left rear mid legs 1pc Right rear mid legs 1pc Right front mid legs 1pc Right + left plate 2pc Front + rear plate 2pc Bottom side 2pc Trundle stopper 5pc Wheels 8pc
D N STEP: Use a cross screwdriver to insert the circular = nut with number D into the circular hole, Pay PCS PCS PCS attention to the horizontal hole position of the circular mut, so that the screw with number A can be fixed smoothly through the mut. 2. Two round mts with number D should be placed at both ends of number 15, and one round nut with number D should be placed at both ends of number 17. STEP: 2 1. Insert the round nut No.
(ammo PCS PCS = | Lb} PCS STEP: 3 ER PCS STEP: 4 1. We need to turn over the installed table, and then put the three in one screw on the table corresponding to the pre drilling position on the table.
STEP: 7 1. First use the number N to connect the bedside and bedside in series, so that we can better fix the screw. 2. Use a cross screwdriver to put the circular nut with number D into the pre drilled hole. Note that the hole of the nut needs to be placed horizontally, so that the screw with number A can pass through the nut horizontally. 3. The screw should be removed from the bottom of the table at the side near the table.
STEP: 8 1. First use the number N to connect the bedside and bedside in series, so that we can better fix the screw. 2. Use a cross screwdriver to put the circular nut with number D into the pre drilled hole. Note that the hole of the nut needs to be placed horizontally, so that the screw with member A can pass through the not horizontally. 3. The screw should be removed from bottom of the table at the side near the table.