Installation Guide

To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
IF SUPPLY WIRES ARE LOCATED WITHIN 3" OF BALLAST, USE WIRE
RATED FOR AT LEAST 90˚C.
• Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
• Use of other manufacturers components will void warranty, listing
a
nd create a potential safety hazard.
• If you are unclear as to how to proceed, contact a qualified
electrician.
• You don’t need special tools to install this fixture.
• Be sure to follow the steps in the order given.
• Read instructions carefully.
• Save these instructions.
IMPORTANT SAFETY INSTRUCTIONS
FIGURE 1
*NO
T SUPPLIED
*OUTLET BOX
FIXTURE
MOUNTING
SCREWS (B)
*WIRE
CONNECTORS
MOUNTING
BAR (A)
*OUTLET BOX
SCREWS
CANOPY (E)
DIFFUSER (F)
CAP NUTS
(E)
CLEANING
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
HC-1491
1
12108
GREEN GROUNDING
SCREW (D)
Secure mounting bar (A) to outlet box with outlet box scr
ews
(not supplied).
STEP 1:
INSTALLATION
A. Use a listed wire connector to connect the fixtur
e hot wire (black
wir
e, or r
ound and smooth tracer) to the supply hot wire.
B. Use a listed wire connector to connect the fixture common wire
(white wire, or square and rigid) to the supply common wire.
C. Gently try to r
emove the wires fr
om the connector
. If you can
r
emove the wires, car
efully re-do the wiring connection.
GROUNDING INSTRUCTIONS: The gr
een grounding screw (D) is to
be inserted into the hole with two raised dimples provided on the
mounting bar (A). Wrap the ground wire from the fixture (if supplied)
and the gr
ound wir
e fr
om the outlet box (bar
e metal or green
insulated wir
e) around the green grounding screw (D) on the
mounting bar (A). If uninsulated ground wire is on the mounting bar,
connect the ground wire from the fixture (if supplied) and the outlet
box to it using a small wir
e connector (not supplied).
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
STEP 2:
STEP 3:
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
ORDERING PARTS
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
BEFORE YOU BEGIN
Make sur
e no bare wir
es can be seen outside wire connectors.
FINAL ASSEMBLY
After wir
es ar
e connected, tuck them car
efully inside outlet box.
Raise the canopy (G) to the ceiling so mounting screws (B) protrude
through holes in canopy (G). Secure in place by threading cap nuts
(E) onto mounting scr
ews (B).
STEP 4:
Install lamps (not supplied).
Raise diffuser (F) to canopy (E) and twist into place to secure.
STEP 5:
STEP 6:
*SUPPLY
GROUND WIRE
FIXTURE
GROUND WIRE