Installation Guide

TORSION SPRINGS (Figure 1): Squeeze the arms together

and insert them into the slotted tabs on the inside of the

housing. Push upward fully so springs will hold trim in place

(see Diagram 1).

TORSION

SPRINGS

SLOTTED

TABS

TRIM

Carefully remove the fixture from the carton and check that all parts

are included, as shown in figure 1 and 2. Be careful not to misplace

ny of the screws or parts which are needed to install this fixture.

• Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

nd create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified

electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Read instructions carefully.

• Save these instructions.

IMPORTANT SAFETY INSTRUCTIONS BEFORE YOU BEGIN:

TORSION

SPRINGS

REFLECTOR INSTALLATION (Figure 2): Snap socket into

hole provided in top of the trim or reflector

Install trim by pressing reflector around lip of trim and turn

clockwise to lock into position.

REFLECTOR

TRIM

SOCKET

SPRINGS

SOCKET

GASKET

TO INSTALL LAMPS: Select proper lamp (see lamp maximum

wattage label in housing). Do not exceed maximum wattage

lamp shown for each trim.

• Snap socket into back of socket plate or trim housing.

• Place rubber washer around lamp neck (flat side towards

can) - shower trim only.

• Thread lamp into socket.

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-1340

32008