User's Manual

ManualsBrandsSe Jin Electron ManualsComputers & Accessories2.4GHz RF KEYBOARD

User’s Manual

1 Operation Manual

[Exterior of Keyboard]

1.1 Connecting keyboard to the USB dongle wirelessly

1. Open the keyboard battery cover on the back and identify the connect button [Figure 1].

[Keyboard Connect Button]

[Figure 1]

Summary of content (4 pages)

PAGE 1
User’s Manual 1 Operation Manual [Exterior of Keyboard] 1.1 Connecting keyboard to the USB dongle wirelessly 1. Open the keyboard battery cover on the back and identify the connect button [Figure 1].
PAGE 2
. Using a paperclip or a small pin, hold down the “Connect” button inside a pinhole on the USB dongle until a RED LED lights up (hold down for about 2-3 seconds) [Figure 2].. [USB Dongle Connect Button shown below] [Figure 2] 3. On the keyboard, press the “Connect” button inside. [Figure 1]. The keyboard will attempt to communicate with the dongle. When they are connected successfully, the red LED on the USB dongle will go out.
PAGE 3
have to start over from the beginning. 1.3 Disconnecting devices 1. Hold down the “Connect” button inside the USB dongle for 3-5 seconds. This will enable the dongle to accept any of 32767 network IDs and disengage from all previous connection settings. Then the red LED will light up for 30 seconds, trying to connect to a new device. 2. When trying to connect a new keyboard or a mouse, follow procedure 1.1 for each device above.
PAGE 4
Blinking Green LED stays on for 1 second When there are two devices connected. 2 second Blinking Green LED stays on for 1.8 second 2.2 Low Battery Status The red LED on the USB dongle will blink when the battery capacity on the connecting keyboard or the mouse goes below 10%. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.