SEJIN ELECTRON INC Device Driver Quick Installation GuideSecuGen® USB Devices For problems or questions, send email to techsupport@secugen.com.
FCC NOTICE THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED OPERATION. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
H/W Installation Testing System Requirements USB Driver CD-ROM drive USB port or hub (must be self-powered if installing SecuGen OptiMouse or Keyboard) 16 MB RAM 20 MB available hard disk space Windows 98(Second Edition or later version) / ME / 2000 / XP General Specification * Performance 1. Verification time : < 1 second under(Pentium II 266MHz) 2. Allowable finger rotation +/- 45 degrees 3. False rejection rate : 0.5% 4. False acceptance rate : 0.001% 5.
Install Drivers using SecuGen’s Easy Installation Program Step 1 Do not connect the USB device until prompted by the program. Step 2 If installing from CD, insert the CD into the CD-ROM drive. If installing from download, click on the file and run setup.exe. Step 3 When the Easy Installation program opens, click on USB Driver. Step 4 Select the device you wish to install. Step 5 Follow the instructions on the screen and connect the device when prompted.
Troubleshooting Tips Device initialized, but fingerprints aren’t captured. SecuGen® USB devices cannot operate at the same time as high speed USB devices like cameras or some audio devices. Such devices must be turned off before fingerprints can be captured due to the USB bandwidth limitation. Device won’t power on. Make sure the SecuGen device is plugged into either the USB port on the host computer or a self-powered hub.
