REFLEXION FILTER® SPACE A S S E M B LY + U S E
sE Electronics RF Space Assembly + Use Thank you for purchasing an sE Electronics RF Space! We hope it helps make your tracks sound great - no matter WHERE you’re recording. STEP ONE a c b The first step is to attach the hardware to the stand, which is done by loosening the metal clamps (a), fitting the stand between them, and tightening the key (b) for a secure fit. If your stand’s diameter is very large or very small, you may have to adjust the large threaded nut (c) opposite the turning key to fit.
sE Electronics RF Space Assembly + Use STEP THREE Now, attach the filter to the L bracket with the two included round screws (f), which go through the vertical cutout on the L bracket and into the two holes in the back of the Space filter (g). f g STEP FOUR h Your microphone, in a shockmount or a clip, will attach to the hardware with the included standoff (h). *The included adapter must be used for 5/8” (US standard) threaded mounts.
sE Electronics RF Space Assembly + Use The ideal placement for your microphone is where the mic’s capsule is approximately even with the front edge of the filter, and centered vertically with the filter – but some mics sound better when pushed a little closer, and some a little further away.