User Manual

T2 – Technical Information
This mic is the ultimate combination of high-detail solid state performance and
versatility. Based on the chassis and feature spec of the acclaimed 4400a, but with the
highly specialised capsule of the original Titan, it delivers full, and perfectly balanced, mid
and low frequencies, while its Titanium capsule produces un-hyped but ultra-detailed
High Frequency (HF) response.
It is thus ideally suited for percussive recordings, including of course drums and
percussion, but also things like picked guitar, the hammer action on piano, kick drum,
slap bass etc.
More, it is the ideal broadcast mic for spoken word; since the intelligibility of any speech
recording comes with good denition of HF (the percussive elements of speech such as
‘p’ and ‘t’ sounds), it is especially important for any mic used to deliver great HF response.
However, simply hyping the HF with an EQ can cause the sound to be sibilant and harsh
sounding, and invariably adds noise. The T2 however delivers a perfectly balanced HF
response due to the extremely fast HF transient response of its Titanium sputtered
capsule, thus giving exceptional intelligibility without the hype and noise.
The T2 - Perfect for percussion and percussive instruments, perfect for spoken word.
Technical Specications
sE Electronics
www.seelectronics.com
Acoustical operating principle
Pressure gradient
transducer
Equivalent noise level, A-
weighted2):
16/16/16 dB-A1)
Dynamic range of the micro-
phone amplier (A-weighted):
106 dB
Directional pattern:
Omnidirectional,
Cardioid, Figure-8 plus
Signal-to-noise ratio, CCIR2)
(rel. 94 dB SPL):
69/68/69 dB1) Supply voltage (P48, IEC
61938) :
48 V ± 4 V
Frequency range: 20 Hz ... 20 kHz
Signal-to-noise ratio, A-
weighted2) (rel. 94 dB SPL) :
78/78/78 dB2) Current consumption (P48, IEC
61938) :
5 mA
Sensitivity at 1 kHz into 1
kohm:
24/25/24 mV/Pa1) Maximum SPL for THD
0.5%3) :
122 dB (cardioid) Matching connectors: XLR3F
Rated impedance: 200 ohms Maximum SPL for THD 0.5%
with preattenuation3) :
132dB Weight: 280g
Rated load impedance: 1 kohms
Maximum SPL for THD 0.5%
with preattenuation3) :
132dB Dimensions:
57mm L X 29mm W X
143mm H
Equivalent noise level, CCIR2) : 25/26/25 dB1) Maximum output voltage: 1000mV
1) According to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2) Measured as equivalent el. input signal
Polar pattern and Frequency Chart
Cardioid
20
10
0
0
dB
Hz
T2